| 1969 Corvette body shell, frame, doors, hood, T-Tops, headlights and other items listed below. The Original Transmission and Rear are included. Ready for a frame off restoration. This is an original 427 400hp, tri-power, 4 speed car. No proof of 400hp other than no evidence of a return fuel line on the frame. If two previous owners storied to me it’s at worst a 390hp. I did not find evidence of Transistor ignition. I’ve taken pictures of the damage to the body and have pictures of major parts. The fenders and rear spoiler have not been messed with. The windshield is cracked and the battery area needs a bottom repair. The firewall area, center tunnel area and the floorpan area look good. The metal framework around the T-Top and windshield are very solid. The front valance is broken. This is a great project car. Body is straight. The front cap has not been separated from the car. It appears to have been painted once. The body is not bolted to the frame and the frame is bare. The frame is straight and in good condition with surface rust. There was some rust thru on the usual places at the rear part of the frame rails and they were repaired or patched before I bought the car. Two square patches. One on either side. I would redo them. This 427 car had air-conditioning, power steering, power brakes, and leather. I wasn’t able to buy the above parts. Don’t know about other options. No build sheet or paper work other than clear title. This 69 Corvette has a D-23 or November 23rd 1968 build date. Trim is 402-984, Black Leather-Daytona Yellow. Transmission: Main Case Housing Casting # 3925660. Extension Housing Casting # 3857584. Sidecover Casting # 39580306. Other parts that are original to the car: Rear differential AT 11 21 68 3.08 Heavy Duty Posi (427), M-20 transmission P9R31A 19S708776 All casting #s correct., Steering box, Power Steering Assembly, RH and LH Trailing Arm Assemblies, RH and LH Front Spindle/Rotor/Calipers, RH and LH Upper and Lower Control Arms, Rear Bumper Brackets, Front Cross member, Fuel Tank Straps/Crossmember, Big Block Hood (chip in center), T-Tops with black panels in place, Rear Glass, RH and LH Headlight Assemblies, Wiper Door and Assembly, Front Bumper Brackets, Half Shafts, Wipers and Linkage, Wiper Door Grill, RH and LH Doors, RH and LH Window Glass, RH and LH Door Regulators, Clutch/Brake Pedal Assemblies, Rear Valance, Hood Strikers/Hinges and Prop Rod, Rear Sway Bar, Front Sway Bar, Drive Shaft, Both Horns, Fuel Door. This Corvette is a project or parts car. No motor or steering column or interior parts. I bought this car as it was being parted out. I didn’t get all the nuts and bolts. I have a clear Georgia title. I have an H-1-68, 2-Bolt 3963512 Block to offer. 19,241 miles. March 2, 2009. |
